A-Plus Aqua Enamel® Water-Based Quick Drying Enamel Paint

Precautions:

1. Surface to be applied on must be thoroughly cleaned, free of any contaminants that can affect adhesion such as wax, oil, grease, moisture, and loose particles.
2. Avoid painting under extreme environmental conditions and/or bad weather conditions.
3. Strip off all loose and chalking paint with A-Plus Supertanggal® Paint Remover.
4. Mix well before using.

For Wooden Surfaces:

1. Surface to be painted must be thoroughly cleaned, free of any contaminants.
2. Hammer nail holes and sand any surface defects with large grit sandpaper for better adhesion.
3. Repair cracks and other surface imperfections with A-Plus® Enamel Glazing Putty followed by light sanding.

For Metal Surfaces:

1. Remove dust, dirt, grease, oil, wax and other foreign matter using a rag soaked in paint thinner.
2. For new Galvanized Iron, wipe clean with paint thinner before sanding surface to enhance paint adhesion. For rusty metal surfaces, wire brush or strip affected areas after applying A-Plus® Rust Converter. Let it sit for 10 – 15 minutes before washing off surface thoroughly with water. Let dry before applying primer.
3. Apply a premium quality metal primer such as A-Plus® Metal Primer or Glazer Galva-Plus® Epoxy Primer immediately upon drying of the surface before rust sets in.